Cisco Aironet 1140 Series 시작하기 매뉴얼 - 페이지 12

{카테고리_이름} Cisco Aironet 1140 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1140 Series 31 페이지. Autonomous access point
Cisco Aironet 1140 Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (35 페이지), 구성 매뉴얼 (40 페이지), 데이터시트 (6 페이지), 시작하기 매뉴얼 (37 페이지)

페이지 인쇄

22/09/2019

Setting

System Name

Con guration Server Protocol DHCP

IP Address

IP Subnet Mask

Default Gateway

Role in Radio Network

Web Server

SNMP Community

Optimize Radio Network for

Aironet Extensions

Note You can restore the access point to its factory defaults by unplugging the power jack and

plugging it back in while holding the Mode button down until the Ethernet LED turns amber

(approximately 2 to 3 seconds).

Enabling the Radio Interfaces

The access point radios are disabled by default, and there is no default SSID. You must create an

SSID and enable the radios before the access point allows wireless associations from other

devices. Refer to the

the SSID.

Follow these steps to enable the radio interfaces:

Step 1 Browse to your access point.

Step 2 When the Summary Status page appears, click 802.11N

page appears.

Step 3 Choose the Settings tab at the top of the page. The Radio Settings page appears.

Step 4 Click Enable in the Enable Radio eld.

https://www.cisco.com/c/en/us/td/docs/wireless/access_point/1140/autonomous/getting_started/guide/ap1140aut_getstart.html

Getting Started Guide: Cisco Aironet 1140 Series Autonomous Access Point - Cisco

Default

Assigned by DHCP

Note The access point does not have a default IP address.

Assigned by DHCP

Access point

Standard (HTTP)

default Community

Throughput

Enable

"Con guring Basic Security Settings" section

for instructions on con guring

2.4GHz

. The 2.4-GHz radio status

12/30