Cisco Aironet 1140 Series 시작하기 매뉴얼 - 페이지 3
{카테고리_이름} Cisco Aironet 1140 Series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1140 Series 31 페이지. Autonomous access point
Cisco Aironet 1140 Series에 대해서도 마찬가지입니다: 시작하기 매뉴얼 (35 페이지), 구성 매뉴얼 (40 페이지), 데이터시트 (6 페이지), 시작하기 매뉴얼 (37 페이지)
페이지 인쇄
22/09/2019
Use the statement number provided at the end of each warning to locate its
translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning Read the installation instructions before you connect the system to its
power source.
Warning This product must be connected to a Power-over-Ethernet (PoE) IEEE
802.3af compliant power source or an IEC60950 compliant limited power source.
Statement 353
Warning This equipment must be externally grounded using a customer-supplied
ground wire before power is applied. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available.
Statement 366
Warning Installation of the equipment must comply with local and national
electrical codes.
Warning This product relies on the building's installation for short-circuit
(overcurrent) protection. Ensure that the protective device is rated not greater than:
20A. Statement 1005
Warning Do not operate your wireless network device near unshielded blasting caps
or in an explosive environment unless the device has been modi ed to be especially
quali ed for such use.
Warning In order to comply with FCC radio frequency (RF) exposure limits, antennas
should be located at a minimum of 7.9 inches (20 cm) or more from the body of all
persons.
Statement 332
https://www.cisco.com/c/en/us/td/docs/wireless/access_point/1140/autonomous/getting_started/guide/ap1140aut_getstart.html
Getting Started Guide: Cisco Aironet 1140 Series Autonomous Access Point - Cisco
Statement 1004
Statement 1074
Statement 245B
3/30