Cisco Aironet 1250 Series 매뉴얼 - 페이지 25
{카테고리_이름} Cisco Aironet 1250 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1250 Series 37 페이지. Aironet 1250 series
Cisco Aironet 1250 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (40 페이지), 데이터시트 (14 페이지), 하드웨어 설치 매뉴얼 (10 페이지)
페이지 인쇄
Follow these steps to connect the access point to an Ethernet LAN when you
are using a local power source:
Step 1
Connect a Category 5E (or higher) Ethernet cable to the RJ-45
Ethernet connector labeled Ethernet on the access point.
Step 2
Connect the 1250 series DC power module's output connector to the
access point's DC-IN power connector.
Step 3
Plug the other end of the Ethernet cable into an unpowered Ethernet
port on your LAN network.
Step 4
Plug the 1250 series DC power module's AC power cord into an
approved 100- to 240-VAC outlet.
Configuring the Access Point
How you configure your access point depends on how you intend to use it in
your wireless network. This guide provides a brief synopsis of the
configuration process. For detailed information, refer to the "Configuring the
Access Point for the First Time" chapter of the Cisco IOS Software
Configuration Guide for Cisco Aironet Access Points for the Cisco IOS
release you are using.
Quick Start Guide: Cisco Aironet 1250 Series Access Point
25