Sony SLT-A55L 서비스 매뉴얼 - 페이지 5

{카테고리_이름} Sony SLT-A55L에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony SLT-A55L 30 페이지. Interchangeable lens digital camera/zoom lens kit

1-1. METHOD FOR REPLACING THE P.O.I.

Method of Removal

(1) Press the MB Mirror Frame Holder Lock SP to raise the P.O.I.

MB Mirror Frame Holder Lock SP

(2) Unjoint the two claws while pressing the P.O.I. backward.

P.O.I.

Claw

1-2. PRECAUTION ON REPLACING THE AM-022 BOARD

Destination Data

When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.

USB Serial No.

The set is shipped with a unique ID (USB Serial No.) written in it.

This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.

SLT-A33/A33L/A33Y/A55/A55V/A55L/A55VL/A55VY_L2

Method of Attachment

(1) When attaching the P.O.I., make the concave side of it face the

front and attach it downward.

P.O.I.

Concave side

Claw

1. SERVICE NOTE

1-3. METHOD FOR CHECKING THE AS SLIDER UNIT (863)

Make sure to confirm below before replacing the AS Slider B Assy or the AS Holder Actuator Assy.

(1) Remove the CV Rear Cover Assy (863), and temporally mount the AS Slider Unit (863).

(2) Set the AS Slider Unit (863) upwards as shown in figure, and put it on a stable place.

Claw

(3) Select "Slider Unit Check" of the adjustment software, and then confirm the movement to the directions of Pitch and Yaw, and if an error occurs,

replace it with the component part corresponding to the movement.

1-1

– ENGLISH –