DIGITEN WTC200 사용자 설명서 - 페이지 5

{카테고리_이름} DIGITEN WTC200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DIGITEN WTC200 8 페이지.
DIGITEN WTC200에 대해서도 마찬가지입니다: 사용자 설명서 (9 페이지), 사용자 설명서 (12 페이지)

Pair/un-pair with the remote

We pair the remote with the receiver. If the remote can't connect to the receiver,

please re-pair according to the methods below:

1. Press and hold

press M button on the remote control to pair the receiver.

2. Press and hold

then flash 2 times quickly before release the button. All remotes will be

unpaired. If you re-pair the remote, please repeat the step 1.

Note： One remote can control multiple receivers (Only WTC100).

Change the temperature unit

Press the

button for 3 seconds to switch the temperature units.

Cooling mode

Set the temperature RUN value higher than the STOP value, the controller is in

cooling mode, and the LCD displays the COOLING symbol

When the CURRENT temperature is higher than the RUN value, the

cooling operation starts, the relay outputs, the LCD displays

green light on the receiver turns on. When the CURRENT value drops

below the STOP value, the cooling operation stops, and the LCD displays

. The green light on the receiver turns off.

When the CURRENT temperature value is lower than the RUN value, the

cooling operation stops, the relay has no output, the LCD displays

the green light on the receiver turns off. When the CURRENT value rises

to the RUN value, the cooling operation starts, the LCD displays

green light on the receiver turns on.

Set the temperature value RUN<STOP, the controller is in heating mode, and

the LCD displays the HEATING symbol

1. When the CURRENT temperature is lower than the RUN value, the

button on the receiver until the LED flashes, then

button on the receiver until the LED flashes 5 times,

, and the

, the