Cisco APP-LSS 설치 및 업그레이드 - 페이지 21

{카테고리_이름} Cisco APP-LSS에 대한 설치 및 업그레이드을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco APP-LSS 32 페이지. Fddi card and appliques

페이지 인쇄

The ribbon cables from your FDDI applique are labeled as follows:

•

FDDI A through D for the ﬁrst applique

•

FDDI E through H for the second applique

•

FDDI I through L for the third applique

•

FDDI M through P for the fourth applique

Connect the four applique ribbon cables to the C2FCIT card as follows.

Caution

To prevent twisting the ribbon cables and causing a possible short circuit, individually

route each cable (from the FDDI applique) under the main card cage through the space provided and

then up to the corresponding C2FCIT card connector.

Connect the applique ribbon cable P3 A, E, I or M (the second cable from the left in

Step 1

Figure 15) to the 26-pin connector labeled FDDI A, E, I, or M on the left front edge of the

C2FCIT card shown in Figure 14.

Step 2

Connect the applique ribbon cable P2 B, F, J, or N (the second cable from the right in

Figure 15) to the 26-pin connector labeled FDDI B, F, J, or N in Figure 14.

Connect the applique ribbon cable P1 C, G, K, or O (the far-right cable in Figure 15) to the

Step 3

26-pin connector labeled FDDI C, G, K, or O in Figure 14.

Connect the applique ribbon cable P4 D, H, L, or P (the far-left cable in Figure 15) to the

Step 4

far-right (16-pin) connector labeled FDDI D, H, L, or P in Figure 14.

Table 4

FDDI Applique Ribbon Cable and CSC-C2FCIT Connector Designations

FDDI Ribbon

From

Cable

Connector

FDDI A, E, I, or M

FDDI B, F, J, or N

FDDI C, G, K, or O P1

FDDI D, H, L, or P

Figure 14

Orientation of the FDDI Connectors on the CSC-C2FCIT Card

FDDI A, E, I, M

To CSC-C2FCIT

Connector

FDDI A, E, I, or M

Serial

FDDI B, F, J, or N

PROM

FDDI C, G, K, or O

U34

FDDI D, H, L, or P

FDDI B, F, J, N FDDI C, G, K, O

Installing and Upgrading the CSC-C2FCIT FDDI Card and Appliques

Installing Cards and Appliques

Microcode

EPROM

U32

FDDI D, H, L, P