Sony MDR-RF845RK 사용 설명서 - 페이지 8

{카테고리_이름} Sony MDR-RF845RK에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony MDR-RF845RK 12 페이지. Wireless stereo headphone sysytem
Sony MDR-RF845RK에 대해서도 마찬가지입니다: 서비스 매뉴얼 (15 페이지), 서비스 매뉴얼 (2 페이지)

페이지 인쇄

Continued

-A Turn up the volume to a moderate

level with the VOL control.

Press the TUNING button briefly for

automatic tuning of the headphones.

If you do not receive a clear audio

signal, press it again.

A MDR-RF845RK

-B Turn up the volume to a moderate

level with the VOL control, then

tune the headphones in to the

frequency of the transmitter with the

TUNING control until you can hear

the audio signal loud and clear.

B MDR-RF815RK

Try the above steps 3 and 5 until the

receiving performance becomes better.

TUNING

button

VOL control

TUNING

control

VOL control

Sending RF signals from the Transmitter

The transmitter starts sending the RF signals

automatically, when it detects audio signals from

the equipment connected.

If it does not detect an audio signal for more than

approximately four minutes, the transmitter will

stop sending RF signals, and the power indicator

turns off.

When the transmitter receives an audio signal

again, it starts sending the RF signals, and the

power indicator will light in red again.

If the audio signal is very weak, the transmitter

does not send RF signals. If the transmitter is

connected to a headphone jack, make sure the

volume of the equipment connected is set to 5 – 6

or higher.

You may not hear the beginning of the sound

from the headphones until the transmitter starts

sending the RF signals after detecting an audio

signal.

Auto power on/off function

When you remove the headphones from your

head, the power turns off automatically. Do not

allow the self adjusting band to be pulled up,

otherwise the headphones will be switched on.

The power turns on.

Note

If a hissing noise is heard move closer to the transmitter.