Cisco ASA 5508-X 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Cisco ASA 5508-X에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5508-X 8 페이지. Threat defense reimage guide
Cisco ASA 5508-X에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (32 페이지), 간편한 설정 매뉴얼 (11 페이지), 빠른 시작 매뉴얼 (9 페이지), 소프트웨어 설명서 (37 페이지), 마운트 및 연결 (6 페이지), 매뉴얼 (14 페이지)

Cisco ASA 5508-X and ASA 5516-X Quick Start Guide

ASDM can change the ASA FirePOWER module IP address settings over the ASA backplane; but for ASDM to

then manage the module, ASDM must be able to reach the module (and its new IP address) on the

Management 1/1 interface over the network. The recommended deployment allows this access because the

module IP address is on the inside network. If ASDM cannot reach the module on the network after you set

the IP address, then you will see an error.

Choose Wizards > Startup Wizard.

Configure additional ASA settings as desired, or skip screens until you reach the ASA FirePOWER Basic

Configuration screen.

Set the following values to work with the default configuration:

—

IP Address—192.168.1.2

—

Subnet Mask—255.255.255.0

—

Gateway—192.168.1.1

Click I accept the agreement, and click Next or Finish to complete the wizard.

10.

Quit ASDM, and then relaunch. You should see ASA FirePOWER tabs on the Home page.

6. Run Other ASDM Wizards and Advanced Configuration

ASDM includes many wizards to configure your security policy. See the Wizards menu for all available wizards.

6. Run Other ASDM Wizards and Advanced Configuration