Cisco ASA 5516-X 마운트 및 연결 - 페이지 4

{카테고리_이름} Cisco ASA 5516-X에 대한 마운트 및 연결을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASA 5516-X 6 페이지. Threat defense reimage guide
Cisco ASA 5516-X에 대해서도 마찬가지입니다: 하드웨어 설치 매뉴얼 (32 페이지), 빠른 시작 매뉴얼 (8 페이지), 간편한 설정 매뉴얼 (11 페이지), 빠른 시작 매뉴얼 (9 페이지), 소프트웨어 설명서 (37 페이지), 매뉴얼 (14 페이지)

Connect to a Console Terminal or PC

Your ASA ships with either ASA or Firepower Threat Defense software preinstalled. To reimage your device,

Note

see

Reimage the Cisco ASA or Firepower Threat Defense

Connect to a Console Terminal or PC

The serial ports provide administrative access to the ASA either with a console terminal or a PC. To configure

the ASA through the CLI, you must establish a connection between the ASA console port and either a terminal

or a PC.

This section describes how to connect to a console terminal or a PC, and contains the following topics:

You must install a USB device driver the first time a Microsoft Windows-based PC is connected to the USB

serial port on the ASA, otherwise the connection fails.

To uninstall the driver, use the Add Remove Programs utility or the Setup-exe program.

Note

Disconnect the ASA console terminal before uninstalling the driver.

Step 1

Obtain the appropriate driver (Cisco_usbconsole_driver_X_X_zip, where X is a revision number) for your ASA model

from the Cisco

Download Software

Step 2

Install the driver.

Step 3

Connect a USB 5-pin Mini USB Type B to the USB console port as shown in the following figure.

Mount and Connect

site, USB Console Software category.

Device.

Mount and Connect