Sony SHAKE5 사용 설명서 - 페이지 33

{카테고리_이름} Sony SHAKE5에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony SHAKE5 40 페이지. Limited warranty (u.s. only)
Sony SHAKE5에 대해서도 마찬가지입니다: 사양 (2 페이지), 제한 보증 (1 페이지)

페이지 인쇄

• The bit rate used when encoding audio

files was low. Send audio files with

higher bit rate to the USB device.

"READING" is displayed for an

extended time, or it takes a long time

before playback starts.

• The reading process can take a long time

in the following cases.

– There are many folders or files on the

USB device (page 14).

– The file structure is extremely

complex.

– The memory capacity is excessive.

– The internal memory is fragmented.

"OVER CURRENT" appears.

• A problem has been detected with the

level of electrical current from the

port or

B port. Turn off the system

and remove the USB device from the

port. Make sure there is no problem with

the USB device. If this display pattern

persists, contact your nearest Sony

dealer.

Erroneous display.

• The data stored in the USB device may

have been corrupted, perform the

transferring again.

• The character code that can be displayed

by this system are as follows:

– Upper cases (A to Z)

– Numbers (0 to 9)

– Symbols (< > * +, [ ] \ _)

Other characters appear as "_".

The USB device is not recognized.

• Turn off the system and reconnect the

USB device, then turn on the system.

• Check the information on the websites

about compatible USB devices

(page 30).

• The USB device does not work

properly. Refer to the operating

instructions of the USB device on how

to deal with this problem.

Playback does not start.

• Turn off the system and reconnect the

USB device, then turn on the system.

• Check the information on the websites

about compatible USB devices

(page 30).

Playback does not start from the first

file.

• Set the play mode to Normal Play

(page 14).

Audio file cannot be played back.

• USB device formatted with file systems

other than FAT16 or FAT32 are

unsupported.*

• A WMA audio file that is the WMA

DRM, WMA Lossless, or WMA PRO

format cannot be played back.

• An AAC audio file that is the AAC

DRM or AAC Lossless format cannot

be played back.

• AAC audio files encoded at 96 kHz

cannot be played back.

• In case multiple partitions exist in USB

device that is being used, files may not

be played back.

• The system can play back to a depth of

8 folders only.

• Files that are encrypted or protected by

passwords and etc. cannot be played

back.

• Files with DRM (Digital Rights

Management) copyright protection

cannot be played back by this system.

• The MP3 PRO audio file can be played

back as MP3 audio file.

* This system supports FAT16 and FAT32, but

some USB device may not support all of these

FAT. For details, refer to the operating

instructions of each USB device or contact the

manufacturer.