Sony ST-SA50ES - Am/fm Tuner 사용 설명서 - 페이지 6
{카테고리_이름} Sony ST-SA50ES - Am/fm Tuner에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony ST-SA50ES - Am/fm Tuner 16 페이지. Fm stereo/ fm-am tuner
Sony ST-SA50ES - Am/fm Tuner에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 기술적 배경 (38 페이지), 치수 (1 페이지), 제한 보증 (1 페이지), 사용 설명서 (14 페이지)
페이지 인쇄
Getting Started
FM Antenna Hookups
With an FM outdoor antenna, you can obtain a higher
FM broadcast sound quality. We recommend you to
use the supplied FM wire antenna only temporarily
until you install an FM outdoor antenna. For the
specific location of the FM ANTENNA terminals, see
the illustration below.
FM ANTENNA
ANTENNA
A
FM
B
75
COAXIAL
Connecting a 75-ohm coaxial cable (not supplied)
The coaxial cable makes the reception more resistant to
external noise. We recommend you to use a 3C-2V type
cable.
1
Strip the cable end.
5
/
16
(8 mm)
2
Remove the lid of the supplied antenna adaptor.
3
Loosen the screw, insert the conductor wire
deeply, and coil the tip around the terminal.
4
Fasten the screw and snap the lid into place.
5
Connect to the FM antenna terminal.
6
LINE OUT
AM
R
L
y
in.
3
/
in.
8
Fold back the mesh wire.
(10 mm)
Remove the short
ring and put it on
the projection on
the lid.
Connecting the supplied 300-ohm twin lead antenna
Since the 300-ohm twin lead picks up external noise easily,
position it carefully.
1
Coil the ends of the antenna around the screws
and tighten them securely.
Keep the short ring
fixed on the adaptor.
2
Connect to the FM antenna terminal.
Extend the upper portion of the FM antenna horizontally.
Connecting a F type connector (not supplied)
z You can use two FM antennas
This tuner has two FM ANTENNA terminals, A and B,
for use with different types of FM antennas. For
example, you can connect an outdoor antenna to the A
jack and connect a cable antenna to the B jack. You can
also switch the antenna while using the signal meter to
determine which antenna gives the best reception for a
particular station.
Connecting a ground wire
If you connect an outdoor antenna, be sure to connect a
ground wire (not supplied) to the AM ANTENNA y
terminal (in addition to the AM loop antenna) for
lightning protection.