Sony ST-SA50ES - Am/fm Tuner 사용 설명서 - 페이지 8

{카테고리_이름} Sony ST-SA50ES - Am/fm Tuner에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony ST-SA50ES - Am/fm Tuner 16 페이지. Fm stereo/ fm-am tuner
Sony ST-SA50ES - Am/fm Tuner에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 기술적 배경 (38 페이지), 치수 (1 페이지), 제한 보증 (1 페이지), 사용 설명서 (14 페이지)

페이지 인쇄

Getting Started

Presetting the Radio Stations

With "Auto Memory" you can automatically store up

to 40 stations in alphabetical order without

redundancy. Additionally, you can set "Auto Memory"

to store only stations with signals that are stronger

than a set level. If you want to store FM or AM stations

one by one, see "Tuning stations (Automatic Tuning)"

and "Storing stations."

BAND

SHIFT

Storing stations automatically

(Auto Memory)

Press MENU.

Turn TUNING/SELECT until "Auto Memory"

appears in the display and press ENTER.

Turn TUNING/SELECT to set 30 dB FM/3 AM,

50 dB FM/5 AM, or 70 dB FM/7 AM as the

minimum signal strength required to be added as

a preset and press ENTER.

The tuner begins scanning in the low end of the

FM frequencies. Stations broadcasting signals

above the minimum level requirement are stored

and assigned a two-character preset code. When

the FM band is complete, scanning continues from

the low end of the AM frequencies.

Notes

• If you move to another area, repeat this procedure to store

stations in your new area.

• For details on tuning stored stations, see page 4.

• The ANTENNA, ANT ATT, IF BAND, and FM MODE

settings are also stored along with the station.

• If you move the antenna after storing stations using "Auto

Mode," the stored settings may no longer be valid. If this

happens, store the stations again.

TUNE

TUNING/

MEMORY

MODE

SELECT

Number

ENTER

buttons

Tuning stations (Automatic Tuning)

With automatic tuning you can quickly tune in a

station without having to know its frequency.

Press BAND to choose either FM or AM.

Press TUNE MODE so that "AUTO TUNING"

appears in the display.

Turn TUNING/SELECT slightly and release it

when the frequency numbers start changing.

Turn the knob to the right for a higher frequency;

turn it to the left for a lower frequency.

When the tuner locates a station, it stops

automatically, "TUNED" appears in the display,

and the signal meter indicates the strength of the

broadcast signal.

Repeat step 3 until you tune in the appropriate

station.

To store the station, see "Storing stations" on page

z If you cannot tune in the station you want

(Manual Tuning)

With manual tuning you can search through all stations

broadcasting on each band, and tune in stations with

extremely weak signals that you might not be able to

receive with automatic tuning.

Press BAND repeatedly to choose FM or AM.

Press TUNE MODE so that only "TUNING"

appears in the display. "AUTO" should not appear

in the display.

Turn TUNING/SELECT until you tune in the

desired station.

Turn the knob to the right for a higher frequency;

turn it to the left for a lower frequency.

The signal meter indicates the strength of the

broadcast signal.

Note

When you reach the highest or lowest frequency of

any band, tuning stops.

When you tune in AM stations

Adjust the direction of the AM loop antenna for

optimum reception.