Sony VideoStore BKSR-2030 설치 매뉴얼 - 페이지 7

{카테고리_이름} Sony VideoStore BKSR-2030에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Sony VideoStore BKSR-2030 14 페이지. Sdi output mpeg decoder board
Sony VideoStore BKSR-2030에 대해서도 마찬가지입니다: 운영 지침 (2 페이지)

페이지 인쇄

1-1. Installing Optional Boards

1. When the optional encoder boards (BKSR-2020/2021) is used, install it to the slot No.1.

The VSR-2000 can accept only one encoder board.

(The VSR-2000 of version 2.0 and higher can accept three encoder boards at a maximum. In such

case, install them starting from the slot No.1 and higher in this order.)

2. Install the decoder boards (BKSR-2030/2031) starting from the slots No.1 to No.5 from the top.

A maximum of five boards including both encoder board (BKSR-2020/2021) and decoder board

(BKSR-2030/2031) can be installed. (The slot No.6 cannot be used.)

Be sure to attach the blank panel to all of the slots that are not used with the blank panels supplied.

(The cooling function of the fan decreases, and the unit could be not operated normally.)

The VSR-2000 is designed to memorize the configuration of the optional boards when the power is

turned on for the first time after shipment.

To change the configuration of the optional boards, change the setting using the supplied BZSR-2000

Trial version that is packed with the VSR-2000.

(For details, refer to the Operation Manual supplied with the CD-ROM of the BZSR-2000 Trial version.)

Before attaching the boards, check the following and set the switches that are required to be set.

. The version of the VSR-2000 to which the BKSR-2030 is to be attached must be version 2.00 or higher.

. To set or change the configuration of the BKSR-2030 using the VSR-2000, the BZSR-2000 Trial

version must be version 2.00 or higher. If the BZSR-2000 Trial version that is supplied with the VSR-

2000 is lower than version 2.00, please contact your local Sony Sales Office/Service Center.

. Before installing the option boards, the default setting may need to be changed depending on the

operating conditions of the system. Change the default setting in accordance with the operating condi-

tions refer to "2-6. Function of Switches/LEDs on Board" of Installation Manual supplied with the

VSR-2000 and "2-1. Description of Internal Switches and Indicator" of the Installation Manual sup-

plied with the respective option boards.

BKSR-2030

Section 1

Installation

BKSR-2020

BKSR-2031

Blank panel

1-1 (E)