Cisco ASR 5500 설치 절차 개요 - 페이지 2

{카테고리_이름} Cisco ASR 5500에 대한 설치 절차 개요을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 5500 6 페이지.
Cisco ASR 5500에 대해서도 마찬가지입니다: 설치 매뉴얼 (31 페이지)

Required Tools and Equipment

8 Connect data cables to the local and external ports.

9 Connect power cables to the PFU terminals at the top rear of the chassis.

10 Apply power to the chassis.

11 Verify that the system powers up successfully.

The actual sequence for completing some of the above procedures may be adapted to suit local requirements

and the availability of resources. For example, power cabling may be completed before circuit cards are

installed in the chassis. However, the chassis must always be grounded immediately after being mounted in

the rack or cabinet.

For personal safety and to minimize the risk of equipment damage, power must not be applied to the

Caution

chassis until all other procedures have been completed.

Required Tools and Equipment

This section lists the tools and equipment needed for installation.

The following hand tools are required for installation of the chassis circuit cards and PFUs:

• Cable/wire stripping tool – used to prepare the ends of power and ground cables for attachment to

• Knife, scissors or tin snips to cut shipping straps on the chassis container.

• Panduit crimping tool with 4 AWG die – used to crimp two-hole lugs on the ends of power feed cables.

• Phillips #2 and #1 screwdrivers – used to tighten thumb-screws on cards, fan trays, PFUs, and mounting

• 7/16-inch nut driver or ratchet and socket set – used to connect power and return, as well as chassis

• Torque wrench (rated 50 in-lb [5.65 N-m]) with 7/16-inch socket for tightening lugs to power terminals.

• Grounding wrist and/or heel straps for prevention of Electro-Static Discharge (ESD).

Caution

The inappropriate use of electric or pneumatic torque drivers, or power drill/impact drivers to loosen or

tighten fasteners may result in damage to system components.

Caution

During installation, maintenance, and/or removal, wear a grounding wrist strap connected to the ASR

5500 chassis to avoid ESD damage to the components. Failure to do so could result in damage to sensitive

electronic components and potentially void your warranty.

ASR 5500 Installation Guide

two-hole lugs.

brackets.

grounding cable lugs to PFU terminals.

Installation Procedure Overview