Cisco ASR 5500 설치 절차 개요

{카테고리_이름} Cisco ASR 5500에 대한 설치 절차 개요을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 5500 6 페이지.
Cisco ASR 5500에 대해서도 마찬가지입니다: 설치 매뉴얼 (31 페이지)

Installation Procedure Overview

This chapter briefly describes the steps and tools that are required to install the ASR 5500 chassis.

Caution

The copper serial Console port, 1000Base-T management ports, and CO alarm interface of the ASR 5500

are suitable for connection to intra-building or unexposed wiring or cabling only. These ports MUST NOT

be metallically connected to interfaces that connect to the outside plant (OSP) or its wiring. These interfaces

are designed for use as intra-building interfaces only (Type 2 or Type 4 ports as described in

GR-1089-CORE, Issue 5) and require isolation from the exposed OSP cabling. The addition of Primary

Protectors is not sufficient protection in order to connect these interfaces metallically to OSP wiring.

It includes the following sections:

•

Installation Sequence

Installation of the ASR 5500 requires the completion of the following procedures:

1 Unpack the chassis and cards.

2 Determine which chassis mounting option to use: flush or mid-mount. Reposition the mounting brackets

if necessary.

3 Install the chassis into a standard 19-inch equipment rack or telecommunications cabinet.

4 Connect the chassis ground point to site ground.

5 Optional: Install the Cable Management System.

6 Install SSC and FSC cards into the front of the chassis.

7 Install MIO/UMIO cards and DPC/UDPCs or DPC2/UDPC2s into the rear of the chassis.

Installation Sequence, page 1

Required Tools and Equipment, page 2

Site Prerequisites, page 3

ESD Precautions, page 4

Standards Compliance, page 5

ASR 5500 Installation Guide