Cisco ASR 9000 Series 매뉴얼 - 페이지 40

{카테고리_이름} Cisco ASR 9000 Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9000 Series 44 페이지. Line card
Cisco ASR 9000 Series에 대해서도 마찬가지입니다: 네트워크 설정 구성 (26 페이지), 구성 매뉴얼 (46 페이지), 구성 매뉴얼 (50 페이지), 매뉴얼 (24 페이지), 구성 (46 페이지), 빠른 참조 매뉴얼 (7 페이지)

페이지 인쇄

Migrating from RSP4/RSP4-S/RSP-L to RSP5 Card

Step 11

Verify RSP5 in slot 1 and RSP in slot 0 reach full synchronization (NSR-ready state) and status of ALL the

groups is Ready state. Use show redundancy command to verify the same.

Example:

Router# show redundancy

Fri Jul 12 20:51:19.365 UTC

Active Node

-----------

0/RSP1/CPU0

Step 12

Remove standby RSP (slot 0). Follow the procedure explained in the topic

from the Chassis, on page

Step 13

Insert and boot RSP5 (slot 0). After booting, the RSP5 becomes standby RSP.

Example:

Router# show platform

Node

--------------------------------------------------------------------------------

0/RSP0/CPU0

0/RSP1/CPU0

0/FT0

0/FT1

0/1/CPU0

0/FC0

0/FC1

0/FC2

0/FC3

0/FC4

0/PT0

0/PT1

Step 14

Repeat Step 6, Step 7 and Step 8.

Step 15

(Optional) Perform FPD upgrade on the RSP5. Use these commands:

Note

Example:

sysadmin-vm:0_RSP1# upgrade hw-module location 0/RSP0 fpd

sysadmin-vm:0_RSP1# upgrade hw-module location 0/RSP1 fpd

Step 16

Reload the system once FPDs are upgraded using the admin hw-module location all reload command.

Replacing Cisco ASR 9000 Series Router Components

Standby Node

------------

0/RSP0/CPU0(Node Ready, NSR:Ready)

25.

Type

A9K-RSP5-TR(Standby)

A9K-RSP5-TR(Active)

ASR-9910-FAN

A9K-8X100GE-TR

A99-SFC-S

A9K-AC-PEM-V3

An FPD upgrade can be performed after all the FCs/LCs are added to the system.

Replacing Cisco ASR 9000 Series Router Components

Removing and Replacing Cards

State

Config state

IOS XR RUN

NSHUT

IOS XR RUN

NSHUT

OPERATIONAL

NSHUT

OPERATIONAL

NSHUT

IOS XR RUN

NSHUT

OPERATIONAL

NSHUT

OPERATIONAL

NSHUT

OPERATIONAL

NSHUT

OPERATIONAL

NSHUT

OPERATIONAL

NSHUT

OPERATIONAL

NSHUT

OPERATIONAL

NSHUT