Digitimer NeuroLog NL405 Width/Delay 사용자 설명서 - 페이지 4

{카테고리_이름} Digitimer NeuroLog NL405 Width/Delay에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitimer NeuroLog NL405 Width/Delay 5 페이지.

Users Manual

Rear Connection IN/OUT jumpers (on-board)

NL405 COMPONENT VIEW

JMP1

JMP2

The rear edge connector in the NL900 rack allows adjacent modules to connected together without the need of

external front panel leads.

This module has a choice of three output signals that can be connected to the rear connector for automatic

routing to the module on the immediate right. The Input signal can be disconnected from the output of the

module on the immediate left if it is inappropriate.

The position of these jumpers are changed by gently pulling them away from the PCB, then rotating them 90°,

180° or 270° before replacing them in two of the small gold board sockets. In the "Parked" or "N/C" position the

jumper is placed in only one gold socket and a parking hole.

INPUT - the upper jumper allows the Output signal from the module to the immediate left to be connected to the

input socket (IN), or it may be "parked" for "no-connection (N/C)".

OUTPUT - the lower jumper selects which of the three Output signals is passed to the Input of the module to

the immediate right, or it may be "parked" for "no-connection (N/C)".

Digitimer Ltd

NeuroLog™ System

Parked

Fig. NL405-3 : On-board IN/OUT jumpers

Page 4 of 5

Tel:+44 (0)1707 328347; Fax:...373153

OUT

Website: www.digitimer.com

NL405

DELAYED