Cisco ATA 191 사용자 설명서 - 페이지 26

{카테고리_이름} Cisco ATA 191에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ATA 191 40 페이지. Analog telephone adapter
Cisco ATA 191에 대해서도 마찬가지입니다: 사용자 설명서 (30 페이지), 관리 매뉴얼 (4 페이지), 사용자 설명서 (10 페이지), 시작하기 (8 페이지), 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (13 페이지), 설정 매뉴얼 (6 페이지), 사용자 설명서 (30 페이지)

Debug Log Viewer

Field

IPv4 Address

IPv6 Address

Port

If logging is enabled on the Administration > Log > Debug Log Viewer page, you can use the Log Viewer

page view the logs online and to download the system log file to your computer. You can limit the contents

of the log by choosing the types of entries to include and by specifying keywords.

For information about enabling and configuring logging, see

Table 11: Debug Log Settings

Field

Download Log

Clear Log

Filter

Use the Administration > Log > Event Log Setting page to collect required event logs. Event log messages

are sent via SYSLOG protocol using UDP transport type.

Use the Event Log Setting when troubleshooting. Four event categories are defined:

• DEV—Device information. A message is sent once device boot-up and network connectivity are ready.

• SYS—System-related information. A message is sent once while device boot-up and network connectivity

• CFG—Status of provision and configuration file change. A message is sent every time the provision

• REG—Registration status for each line. A message is sent every time registration status changes.

Enter the settings as described below. After making changes, click Submit to save your settings, or click

Cancel to redisplay the page with the saved settings.

Cisco ATA 191 and ATA 192 Analog Telephone Adapter User Guide for Multiplatform Firmware

are ready.

service restarts due to configuration or network status change.

Description

Enter the IPv4 address of the debug log server where the messages will

be sent.

Enter the IPv6 address of the debug log server where the messages will

be sent.

Enter the port to use on the server. Valid values are from 1 to 65535.

Debug Log Module, on page

Description

Click this button to download the contents of the log as a file on your

computer. In the dialog box, you can open the file or save it. The file

can be opened in a text editor such as Notepad.

Click this button to remove all entries from the log.

Enter a keyword to filter the log entries that appear in the viewer. The

page will display only the entries that include the keyword.

Configure Features

19.