Argo Vanguard 2 서비스 매뉴얼 - 페이지 12

{카테고리_이름} Argo Vanguard 2에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo Vanguard 2 16 페이지. Ducting & exhaust

Argo Vanguard 2 서비스 매뉴얼
Argo Service Manual
Removing the Muffler (Bigfoot Models)
1.
Remove the four fasteners securing the muffler heat shield and remove the shield.
2.
Disconnect the extension springs between the tailpipe and muffler and pull the
tailpipe from the engine compartment.
3.
Remove the muffler at the engine

Installing the Muffler (Bigfoot Models)

Always replace exhaust gaskets when servicing the muffler system.
1.
Attach the muffler at the engine and torque to specifications
2.
Slip the tailpipe, from the engine compartment side, through the exhaust screen hole
and connect at the muffler with 2 extension springs.
3.
Assemble the heat shield to the top of the muffler using the 4 fasteners required.
Spark Arrestors
Cleaning the Spark Arrestor (Only for equipped models)
Models Equipped with Spark Arrestors.
Conquest
Response
Bigfoot
Vanguard2
Vanguard
Conquest 6x6
After operating the engine, do not touch any part of the exhaust system until it has
sufficient time to cool!
1.
Keep a record of the number of hours of engine use. The spark arrester should be
removed, cleaned and inspected every 50 hours of operation.
Ontario Drive & Gear Limited
PH.(519)- 662-2840 FAX (519)- 662-2421
IMPOR
IMPORT T T T T ANT
IMPOR
ANT
ANT
IMPOR
IMPOR
ANT
ANT
All Models
Models manufactured from R19647
Models manufactured from BF13028
Models manufactured from N13436
Models manufactured from S13434
Models manufactured from C12747
DE-11
Ducting & Exhaust
www.odg.com