Argo Vanguard 2 서비스 매뉴얼 - 페이지 13

{카테고리_이름} Argo Vanguard 2에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo Vanguard 2 16 페이지. Ducting & exhaust

Ducting & Exhaust

Remove the tail pipe assembly by disconnecting the springs from the muffler at-

tached to the tail pipe.

The screen-type spark arrester assembly is located inside the tail pipe. It is fastened

with one (1) slotted washer-head hex screw. Find the screw on the side of the outlet

tube.

Remove the screw and save it for step 9.

Take off the screen-type spark arrester assembly.

Shake loose particles out of the screen assembly.

Clean the screen with a wire brush. (Soak it in oil solvent if necessary.)

If any breaks in the screen or weldments are discovered, replace the assembly.

Return the screen assembly to the outlet tube and refasten it with the screw from

Step 4.

Removing the Intake Duct (Response, Bigfoot, Vanguard2 & Vanguard Models)

Locate the 2 fasteners securing the intake duct to the hood frame assembly and re-

move. There are 2 spacers assembled with the fasteners. Photo DE-29

Undo the fuel line from the nylon clips securing it to the intake duct.

Pull the ducting from the vehicle. Navigate it towards the front of the vehicle pulling

it up, and out. Photo DE-30

6x6 Vanguards manufactured prior to S8131 will have a spring attached at the rear of the

intake and connected to a small molly hook that is riveted to the lower body wheel well.

See the appropriate illustrated parts manual.

Ontario Drive & Gear Limited

PH.(519)- 662-2840 FAX (519)- 662-2421

DE-29

DE-12

Argo Service Manual

DE-30