Cisco Cisco mds 9216 - fabric switch 하드웨어 설치 매뉴얼 - 페이지 2

{카테고리_이름} Cisco Cisco mds 9216 - fabric switch에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Cisco mds 9216 - fabric switch 36 페이지. Multilayer fabric switch
Cisco Cisco mds 9216 - fabric switch에 대해서도 마찬가지입니다: 연결 매뉴얼 (13 페이지), 구성 매뉴얼 (49 페이지), 릴리스 노트 (48 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (36 페이지), 릴리스 노트 (26 페이지), 릴리스 노트 (22 페이지), 빠른 참조 매뉴얼 (14 페이지), 릴리스 노트 (3 페이지), 사양 (11 페이지)

페이지 인쇄
Cisco Cisco mds 9216 - fabric switch 하드웨어 설치 매뉴얼

Pre-Installation

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
IMPORTANT SAFETY INSTRUCTIONS
Warning
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
This unit is intended for installation in restricted access areas. A restricted access area can be
Warning
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Warning
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement
1022
Each new switch requires a license; refer to
Note
http://www.cisco.com/univercd/cc/td/doc/product/sn5000/mds9000/index.htm
9000 Family configuration guides containing information on this feature.
Pre-Installation
This section includes the following information:
•
•
•
•
Installation Options
The Cisco MDS 9216 Switch can be installed using the following methods:
•
Cisco MDS 9216 Switch Hardware Installation Guide
2-2
Installation Options, page 2-2
Installation Guidelines, page 2-3
Required Equipment, page 2-4
Unpacking and Inspecting the Switch, page 2-4
In an open EIA rack, using:
–
The rack-mount kit shipped with the switch
–
The Telco and EIA Shelf Bracket Kit part number DS-SHELF= (an optional kit, purchased
separately) in addition to the rack-mount kit shipped with the switch
Chapter 2
Installing the Cisco MDS 9216 Switch
for the latest Cisco MDS
OL-6985-01