Cisco Cisco mds 9216 - fabric switch 하드웨어 설치 매뉴얼 - 페이지 4

{카테고리_이름} Cisco Cisco mds 9216 - fabric switch에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Cisco mds 9216 - fabric switch 36 페이지. Multilayer fabric switch
Cisco Cisco mds 9216 - fabric switch에 대해서도 마찬가지입니다: 연결 매뉴얼 (13 페이지), 구성 매뉴얼 (49 페이지), 릴리스 노트 (48 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (36 페이지), 릴리스 노트 (26 페이지), 릴리스 노트 (22 페이지), 빠른 참조 매뉴얼 (14 페이지), 릴리스 노트 (3 페이지), 사양 (11 페이지)

Cisco Cisco mds 9216 - fabric switch 하드웨어 설치 매뉴얼
Pre-Installation
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
To prevent loss of input power, ensure the total maximum loads on the circuits supplying power to the
Caution
switch are within the current ratings for the wiring and breakers.
Required Equipment
Gather the following items before beginning the installation:
The following additional items (not found in the accessory kit) are required to ground the chassis:
Unpacking and Inspecting the Switch
Caution
When handling switch components, wear an ESD strap and handle modules by the carrier edges only.
An ESD socket is provided on the chassis. For the ESD socket to be effective, the chassis must be
grounded through the power cable, the chassis ground, or the metal-to-metal contact with a grounded
rack.
Tip
Keep the shipping container in case the chassis requires shipping in the future.
Cisco MDS 9216 Switch Hardware Installation Guide
2-4
Ensure that circuits are sized according to local and national codes. For North America, the 845-W
power supply requires a 15-A or 20-A circuit.
If you are using a 200- or 240-VAC power source in North America, the circuit must be protected
by a two-pole circuit breaker.
Use the following screw torques when installing the switch:
Captive screws: 4 in-lb
M3 screws: 4 in-lb
M4 screws: 12 in-lb
10-32 screws: 20 in-lb
12-24 screws: 30 in-lb
Number 1 and number 2 Phillips screwdrivers with torque capability
3/16-in. flat-blade screwdriver
Tape measure and level
ESD wrist strap or other grounding device
Antistatic mat or antistatic foam
Grounding cable (6 AWG recommended), sized according to local and national installation
requirements; the required length depends on the proximity of the Cisco MDS 9216 Switch to proper
grounding facilities
Crimping tool large enough to accommodate girth of lug
Wire-stripping tool
Chapter 2
Installing the Cisco MDS 9216 Switch
OL-6985-01