Cisco Cisco mds 9216 - fabric switch 하드웨어 설치 매뉴얼 - 페이지 33

{카테고리_이름} Cisco Cisco mds 9216 - fabric switch에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Cisco mds 9216 - fabric switch 36 페이지. Multilayer fabric switch
Cisco Cisco mds 9216 - fabric switch에 대해서도 마찬가지입니다: 연결 매뉴얼 (13 페이지), 구성 매뉴얼 (49 페이지), 릴리스 노트 (48 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (44 페이지), 릴리스 노트 (36 페이지), 릴리스 노트 (26 페이지), 릴리스 노트 (22 페이지), 빠른 참조 매뉴얼 (14 페이지), 릴리스 노트 (3 페이지), 사양 (11 페이지)

Chapter 2

Installing the Cisco MDS 9216 Switch

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .

Turn the power switch to the on (|) position on the power supply.

Step 8

Verify power supply operation by checking that the power supply LEDs are in the following states:

Step 9

•

If the LEDs indicate a power problem, see the

page

Removing and Installing the Fan Module

The fan module is designed to be removed and replaced while the system is operating without presenting

an electrical hazard or damage to the system, provided the replacement is performed promptly.

This section provides the following information:

•

You will need a flat-blade or number 2 Phillips screwdriver to perform these procedures.

The Cisco MDS 9000 Family switches have internal temperature sensors that are capable of shutting

Caution

down the system if the temperature at different points within the chassis exceed certain safety thresholds.

To be effective, the temperature sensors require the presence of airflow; therefore, in the event a fan

module is removed from the chassis, the Cisco MDS 9000 Family switches will be shut down after five

minutes to prevent potentially undetectable overheating. However, the switches will shut down sooner if

the higher-level temperature threshold is exceeded.

Figure 2-22

Figure 2-22 Fan Module

OL-6985-01

Input Ok LED is green.

Fan Ok LED is green.

Output Fail LED is off.

B-3.

Removing a Fan Module, page 2-34

Installing a Fan Module, page 2-34

shows a fan module partially installed in the Cisco MDS 9216 Switch.

M DS 92 16

Removing and Installing Components

"Troubleshooting the Power Supplies" section on

Cisco MDS 9216 Switch Hardware Installation Guide

2-33