Cisco Cisco mds 9216 - fabric switch Hardware installatiehandleiding - Pagina 33

Blader online of download pdf Hardware installatiehandleiding voor {categorie_naam} Cisco Cisco mds 9216 - fabric switch. Cisco Cisco mds 9216 - fabric switch 36 pagina's. Multilayer fabric switch
Ook voor Cisco Cisco mds 9216 - fabric switch: Aansluithandleiding (13 pagina's), Configuratiehandleiding (49 pagina's), Release Release (48 pagina's), Release Release (44 pagina's), Release Release (44 pagina's), Release Release (36 pagina's), Release Release (26 pagina's), Release Release (22 pagina's), Snelle referentiehandleiding (14 pagina's), Release Release (3 pagina's), Specificatie (11 pagina's)

Pagina afdrukken
Cisco Cisco mds 9216 - fabric switch Hardware installatiehandleiding
Chapter 2
Installing the Cisco MDS 9216 Switch
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m .
Turn the power switch to the on (|) position on the power supply.
Step 8
Verify power supply operation by checking that the power supply LEDs are in the following states:
Step 9
•
•
•
If the LEDs indicate a power problem, see the
page
Removing and Installing the Fan Module
The fan module is designed to be removed and replaced while the system is operating without presenting
an electrical hazard or damage to the system, provided the replacement is performed promptly.
This section provides the following information:
•
•
You will need a flat-blade or number 2 Phillips screwdriver to perform these procedures.
The Cisco MDS 9000 Family switches have internal temperature sensors that are capable of shutting
Caution
down the system if the temperature at different points within the chassis exceed certain safety thresholds.
To be effective, the temperature sensors require the presence of airflow; therefore, in the event a fan
module is removed from the chassis, the Cisco MDS 9000 Family switches will be shut down after five
minutes to prevent potentially undetectable overheating. However, the switches will shut down sooner if
the higher-level temperature threshold is exceeded.
Figure 2-22
Figure 2-22 Fan Module
OL-6985-01
Input Ok LED is green.
Fan Ok LED is green.
Output Fail LED is off.
B-3.
Removing a Fan Module, page 2-34
Installing a Fan Module, page 2-34
shows a fan module partially installed in the Cisco MDS 9216 Switch.
M DS 92 16
Removing and Installing Components
"Troubleshooting the Power Supplies" section on
Cisco MDS 9216 Switch Hardware Installation Guide
2-33