Digitone ProSeries II Call Blocker 운영 매뉴얼 - 페이지 4

{카테고리_이름} Digitone ProSeries II Call Blocker에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitone ProSeries II Call Blocker 17 페이지. Automatically blocks and routes screened calls using caller id with back lighted display

Digitone ProSeries II Call Blocker 운영 매뉴얼
To Remove the entire Call History Press and Hold the Delete Entry Button, then
Confirm Delete, you will then see "CID List Deleted" displayed, clearing all Call History.

Program Dial

BLUE
(left) Button – The Dial button lets you dial the number shown
in the display. Tap once to start the dialing process. The Program button allows you
to change the default settings of the DPCB using programming. Press and hold the
Program button or use the remote command # # or *** to enter programming.
Clearing Display – One Number - Delete Entry
BLUE
(right) Button
To delete a single number from Call History, use the Call History Up or Down
arrow keys to select the number you want to remove. Tap the Delete Entry Button
Once, "Confirm Delete?" will then show. To clear that displayed call, tap Delete Entry
Button again. This does not delete any entries you stored in caller lists.
Clearing Display – All Numbers - Delete Entry
BLUE
(right) Button
To remove the entire Call History, Press and hold the Delete Entry Button for 3
seconds, you will then see "Release Button".
"CID List Deleted" will then display,
clearing Call History items. This does not delete any entries you stored in caller lists.
Reviewing Call History
GRAY
Buttons - The left Up arrow button displays the
previous calls or Top of List. The right button Down arrow button displays the last call
or End of List. When Call History starts to fill up with calls, you can jump to the Top
of List by pressing and holding the Up arrow key or pressing and holding the Down
arrow key to go to the End of List.

Caller ID Display

Automatic Call Blocking and Routing

Caller ID service from your phone company is required for Digitone's ProSeries
Call
II
Blocker to work. The first call to your DPCB unit will initialize the Clock and Date to
the current date and time. Automatic call routing will begin to work right after the first
call when Caller ID information is displayed. Note that during Daylight Savings Time
changes, the phone company is responsible for updating their clock data when
delivering the caller ID information.
3