Cisco Firepower 2110 매뉴얼 - 페이지 5

{카테고리_이름} Cisco Firepower 2110에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 2110 12 페이지. Rack-mount and ground the chassis
Cisco Firepower 2110에 대해서도 마찬가지입니다: 소프트웨어 설명서 (37 페이지), 배포 매뉴얼 (8 페이지), 시작하기 (42 페이지)

페이지 인쇄

Rack-Mount and Ground the Chassis

Warning

Step 1

Attach the slide-rail locking brackets to each side of the chassis using the six 8-32 x 0.375-inch Phillips screws (three

per side).

Statement 1006 Chassis Warning for Rack-Mounting and Servicing

To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions

to ensure that the system remains stable. The following guidelines are provided to ensure your safety:

• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.

• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the

heaviest component at the bottom of the rack.

• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing

the unit in the rack.

Statement 1024 Ground Conductor

This equipment must be grounded. To reduce the risk of electric shock, never defeat the ground conductor

or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate

electrical inspection authority or an electrician if you are uncertain that suitable grounding is available.

Statement 1030 Equipment Installation

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1047 Overheating Prevention

To reduce the risk of fire or bodily injury, do not operate the unit in an area that exceeds the maximum

recommended ambient temperature of: 40 degrees C

Statement 1073 No User-Serviceable Parts

There are no serviceable parts inside. To avoid risk of electric shock, do not open.

Rack-Mount the Chassis Using Slide Rails

Rack-Mount and Ground the Chassis