Cisco Firepower 4110 시작하기 - 페이지 13

{카테고리_이름} Cisco Firepower 4110에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 4110 42 페이지. Rack-mount and ground the chassis
Cisco Firepower 4110에 대해서도 마찬가지입니다: 유지 관리 및 업그레이드 매뉴얼 (20 페이지), 매뉴얼 (36 페이지), 매뉴얼 (26 페이지), 매뉴얼 (8 페이지), 매뉴얼 (42 페이지)

페이지 인쇄

Getting Started

Cabling for the Firepower 1010

Figure 1: Cabling the Firepower 1010

• Connect your management computer to one of the following interfaces:

• Connect the outside network to the Ethernet 1/1 interface.

• Connect inside devices to the remaining switch ports, Ethernet 1/2 through 1/8.

• Ethernet 1/2 through 1/8—Connect your management computer directly to one of the inside switch

ports (Ethernet 1/2 through 1/8). inside has a default IP address (192.168.95.1) and also runs a

DHCP server to provide IP addresses to clients (including the management computer), so make sure

these settings do not conflict with any existing inside network settings.

• Management 1/1—Connect your management computer to the management network. The

Management 1/1 interface obtains an IP address from DHCP, so make sure your network includes

a DHCP server.

If you need to change the Management 1/1 IP address from the default to configure a static IP

address, you must also cable your management computer to the console port. See

Management Network Settings at the CLI, on page

You can later configure management access from other interfaces.

By default, the IP address is obtained using IPv4 DHCP and IPv6 autoconfiguration, but you can set a

static address during initial configuration.

Ethernet 1/7 and 1/8 are Power over Ethernet+ (PoE+) ports.

Cabling for the Firepower 1010

21.

Getting Started

(Optional) Change