Cisco Firepower 9300 설치 및 유지 관리 - 페이지 11

{카테고리_이름} Cisco Firepower 9300에 대한 설치 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 9300 36 페이지. Installation, maintenance, and upgrade guide
Cisco Firepower 9300에 대해서도 마찬가지입니다: 시작하기 (42 페이지)

페이지 인쇄

Installation, Maintenance, and Upgrade

Step 1

To install a new network module for the first time into an empty slot, do the following:

a) Power down the chassis by moving the power switch to the OFF position.

b) Follow Steps 5 through 7 to install the new network module.

c) Power on the chassis by moving the power switch to the ON position.

The state for the new network module is

d) To change the status of the network module to

Chassis" topic in the System Administration chapter in the

Step 2

To remove and replace an existing network module, do one of the following:

a) Save your configuration.

b) Power down the chassis by moving the power switch to the OFF position (if removing a network module that does

not support hot swapping).

c) Bring the network module offline using the appropriate CLI command (if removing a network module that supports

hot swapping). All network module configuration is saved. See the "Taking a Network Module Offline or Online"

topic in the Security Module/Engine Management chapter in the

d) Continue with Step 3.

Step 3

To remove the network module, loosen the captive screw on the left of the network module, release the handle until it is

fully rotated, and then gently pull the network module out of the chassis.

Install, Remove, and Replace the Single-Wide Network Module

OIR Failed

, reboot the chassis. See the "Rebooting the Firepower 4100/9300

Online

FXOS Configuration Guide

Installation, Maintenance, and Upgrade

for your software version.