Cisco Firepower 9300 설치 및 유지 관리 - 페이지 12

{카테고리_이름} Cisco Firepower 9300에 대한 설치 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Firepower 9300 36 페이지. Installation, maintenance, and upgrade guide
Cisco Firepower 9300에 대해서도 마찬가지입니다: 시작하기 (42 페이지)

페이지 인쇄

Install, Remove, and Replace the Single-Wide Network Module

Figure 5: Remove and Replace the Single-Wide Network Module

If the slot is to remain empty, install a blank faceplate to ensure proper airflow and to keep dust out of the chassis;

otherwise, install another network module.

Step 4

(Optional) If you are installing a single-wide network module into a double-wide slot, you must install a divider. The

blank faceplates are for a single slot, so install the divider if you are covering two single network slots.

Note

The original 9300 chassis and the newer 9300 chassis have different dividers. You can order FPR9K-NM-DIV=,

which contains a screw and both dividers in case you have lost the divider (part number 800-101936-01) for

the older chassis or you need the new divider (part number 700-112465-01) for the newer chassis.

Step 5

To install a new network module, hold the network module in front of the network module slot on the right side of the

chassis with the handle fully extended. Slowly push the module into the network module slot until the handle catches on

the mating feature in the chassis. The handle should engage correctly.

Step 6

Gently push on the handle until it is fully seated on the network module faceplate and the module is fully seated in the

chassis.

Step 7

Tighten the captive screw on the left of the network module.

Step 8

Do one of the following:

Installation, Maintenance, and Upgrade