Cisco Firepower 9300 Installation & Maintenance - Page 12
Browse online or download pdf Installation & Maintenance for Network Hardware Cisco Firepower 9300. Cisco Firepower 9300 36 pages. Installation, maintenance, and upgrade guide
Also for Cisco Firepower 9300: Getting Started (42 pages)
Install, Remove, and Replace the Single-Wide Network Module
Figure 5: Remove and Replace the Single-Wide Network Module
If the slot is to remain empty, install a blank faceplate to ensure proper airflow and to keep dust out of the chassis;
otherwise, install another network module.
Step 4
(Optional) If you are installing a single-wide network module into a double-wide slot, you must install a divider. The
blank faceplates are for a single slot, so install the divider if you are covering two single network slots.
Note
The original 9300 chassis and the newer 9300 chassis have different dividers. You can order FPR9K-NM-DIV=,
which contains a screw and both dividers in case you have lost the divider (part number 800-101936-01) for
the older chassis or you need the new divider (part number 700-112465-01) for the newer chassis.
Step 5
To install a new network module, hold the network module in front of the network module slot on the right side of the
chassis with the handle fully extended. Slowly push the module into the network module slot until the handle catches on
the mating feature in the chassis. The handle should engage correctly.
Step 6
Gently push on the handle until it is fully seated on the network module faceplate and the module is fully seated in the
chassis.
Step 7
Tighten the captive screw on the left of the network module.
Step 8
Do one of the following:
Installation, Maintenance, and Upgrade
12
Installation, Maintenance, and Upgrade