Cisco Firepower 9300 Installation & Maintenance

Browse online or download pdf Installation & Maintenance for Network Hardware Cisco Firepower 9300. Cisco Firepower 9300 36 pages. Installation, maintenance, and upgrade guide
Also for Cisco Firepower 9300: Getting Started (42 pages)

Print Page

Installation, Maintenance, and Upgrade

•

Remove and Replace the Supervisor

You can remove the Firepower 9300 Supervisor while the system is powered on without damage to the

Supervisor hardware or system. However, because the supervisor is controlling the entire chassis, including

the power system, we recommend that you use the power switch on the rear panel of the chassis to put the

system in standby mode. See

Safety Warnings

Warning

Remove and Replace the Supervisor, on page 1

Install, Remove, and Replace the Security Module, on page 3

Remove and Replace the SSD, on page 6

Install, Remove, and Replace the Single-Wide Network Module, on page 8

Install, Remove, and Replace the Double-Wide Network Module, on page 13

Remove and Replace the Power Supply Module, on page 17

Connect the DC Power Supply Module, on page 22

Connect the HVDC Power Supply Module, on page 25

Remove and Replace the Fan Module, on page 29

Install the FIPS Opacity Shield, on page 32

Supervisor

Take note of the following component replacement safety warnings:

Statement 1028 More Than One Power Supply

This unit might have more than one power supply connection. To reduce risk of electric shock,

remove all connections to de-energize the unit.

for more information about the Supervisor.

Installation, Maintenance, and Upgrade