Cisco Firepower 9300 Installation & Maintenance - Page 17

Browse online or download pdf Installation & Maintenance for Network Hardware Cisco Firepower 9300. Cisco Firepower 9300 36 pages. Installation, maintenance, and upgrade guide
Also for Cisco Firepower 9300: Getting Started (42 pages)

Print Page

Installation, Maintenance, and Upgrade

Figure 8: Install the 100-Gb Network Module

Step 5

Gently push on the handle until it is fully seated on the network module faceplate and the module is fully seated in the

chassis.

Step 6

Tighten the captive screw on the left of the network module.

Step 7

Power on the chassis so that the new network module is recognized.

Follow the procedures in the

been discovered correctly by the Firepower 9300.

Remove and Replace the Power Supply Module

You can remove and replace the power supply module while the system is running. Make sure that at least

one of the power supply modules is active while hot-swapping.

Note

FXOS Configuration Guide

Replace power supplies immediately. Power supply blanks are not available.

Remove and Replace the Power Supply Module

to connect to the network module and make sure that it has

Installation, Maintenance, and Upgrade