Cisco Firepower 9300 Installatie en onderhoud - Pagina 17
Blader online of download pdf Installatie en onderhoud voor {categorie_naam} Cisco Firepower 9300. Cisco Firepower 9300 36 pagina's. Installation, maintenance, and upgrade guide
Ook voor Cisco Firepower 9300: Aan de slag (42 pagina's)
Pagina afdrukkenInstallation, Maintenance, and Upgrade
Figure 8: Install the 100-Gb Network Module
Step 5
Gently push on the handle until it is fully seated on the network module faceplate and the module is fully seated in the
chassis.
Step 6
Tighten the captive screw on the left of the network module.
Step 7
Power on the chassis so that the new network module is recognized.
Follow the procedures in the
been discovered correctly by the Firepower 9300.
Remove and Replace the Power Supply Module
You can remove and replace the power supply module while the system is running. Make sure that at least
one of the power supply modules is active while hot-swapping.
Note
FXOS Configuration Guide
Replace power supplies immediately. Power supply blanks are not available.
Remove and Replace the Power Supply Module
to connect to the network module and make sure that it has
Installation, Maintenance, and Upgrade
17