Cisco Firepower 9300 Instalasi & Pemeliharaan - Halaman 17
Jelajahi secara online atau unduh pdf Instalasi & Pemeliharaan untuk Perangkat Keras Jaringan Cisco Firepower 9300. Cisco Firepower 9300 36 halaman. Installation, maintenance, and upgrade guide
Juga untuk Cisco Firepower 9300: Memulai (42 halaman)
Halaman CetakInstallation, Maintenance, and Upgrade
Figure 8: Install the 100-Gb Network Module
Step 5
Gently push on the handle until it is fully seated on the network module faceplate and the module is fully seated in the
chassis.
Step 6
Tighten the captive screw on the left of the network module.
Step 7
Power on the chassis so that the new network module is recognized.
Follow the procedures in the
been discovered correctly by the Firepower 9300.
Remove and Replace the Power Supply Module
You can remove and replace the power supply module while the system is running. Make sure that at least
one of the power supply modules is active while hot-swapping.
Note
FXOS Configuration Guide
Replace power supplies immediately. Power supply blanks are not available.
Remove and Replace the Power Supply Module
to connect to the network module and make sure that it has
Installation, Maintenance, and Upgrade
17