Cisco Gigabit Switch Router Cisco 12012 설치 지침 매뉴얼 - 페이지 4
{카테고리_이름} Cisco Gigabit Switch Router Cisco 12012에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Gigabit Switch Router Cisco 12012 14 페이지. Gigabit switch router cablemanagement
kit
Cisco Gigabit Switch Router Cisco 12012에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (34 페이지), 교체 지침 매뉴얼 (6 페이지), 데이터시트 (9 페이지), 교체 지침 매뉴얼 (20 페이지)
페이지 인쇄
Safety Guidelines
Safety Guidelines
Before you begin the procedures in this document, review the safety guidelines in this section to
avoid injuring yourself or damaging the equipment.
In addition, review the safety warnings listed in the document Regulatory Compliance and Safety
Information for the Cisco 12012 Gigabit Switch Router (Document Number 78-4347-xx) that
supports your Cisco 12012 before installing, configuring, or maintaining the router.
Safety with Equipment
The following guidelines will help ensure your safety and protect the equipment. This list is not
inclusive of all potentially hazardous situations, so be alert.
•
•
•
•
•
Safety with Electricity
The line cards, RP, switch fabric cards, alarm card, blower modules, and redundant power supplies
are designed to be removed and replaced while the system is operating without presenting an
electrical hazard or damage to the system.
Follow these basic guidelines when working with any electrical equipment:
•
•
•
•
•
•
•
4 Cisco 12012 Gigabit Switch Router Cable- Management Kit Installation Instructions
Always disconnect all power cords and interface cables before moving the card cage assembly.
Keep tools and assembly components away from walk areas.
Do not work alone if potentially hazardous conditions exist.
Do not perform any action that creates a potential hazard to people or makes the equipment
unsafe.
Carefully examine your work area for possible hazards such as moist floors, ungrounded power
extension cables, and missing safety grounds.
Before beginning any procedures requiring access to the interior of the Cisco 12012, locate the
emergency power-off switch for the room in which you are working.
Look carefully for possible hazards in your work area, such as moist floors, ungrounded power
extension cables, and missing safety grounds.
If an electrical accident occurs, proceed as follows:
— Use caution; do not become a victim yourself. Disconnect power to the system.
— If possible, send another person to get medical aid. Otherwise, assess the condition of the
victim and then call for help.
— Determine if the person needs rescue breathing or external cardiac compressions; then take
appropriate action.
Disconnect all power and external cables before installing or removing a router.
Never assume that power has been disconnected from a circuit; always check.
Do not perform any action that creates a potential hazard to people or makes the equipment
unsafe.
Never install equipment that appears damaged.