Cisco IAD2430 Series 빠른 시작 매뉴얼 - 페이지 13

{카테고리_이름} Cisco IAD2430 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco IAD2430 Series 34 페이지. Integrated access device
Cisco IAD2430 Series에 대해서도 마찬가지입니다: 개요 매뉴얼 (13 페이지), 개요 (16 페이지)

페이지 인쇄

Figure 11

Cisco IAD2435 IAD Rack-Mounting with Back Panel Forward

Install the chassis in the rack, using screws that you purchase.

Step 2

Setting the Chassis on a Desktop

You can set the Cisco IAD2430 series IADs on a desktop. To place the Cisco IAD2430, Cisco IAD2431, or Cisco IAD2432 IAD

on a desktop follow these steps:

Verify that a suitable AC power outlet is available.

Step 1

Do not plug this unit into an AC outlet that does not have a UL-certified receptacle that is properly tied into the

Caution

building ground.

Place the four rubber feet (from the accessory kit) in the four indentations on the underside of the chassis. The slight

Step 2

elevation provided by the rubber feet helps provide proper airflow through and around the chassis.

Step 3

Place the Cisco IAD on a smooth, flat surface.

Do not place anything on top of the chassis that weighs more than 10 lb (4.5 kg). Excessive weight on top can

Caution

damage the chassis.

Setting the Cisco IAD2435 on a Desktop

You can also place the Cisco IAD2435 IAD on a desktop. To place the Cisco IAD2435 IAD on a desktop follow the preceding

steps.

Do not place anything on top of the router that weighs more than 5 pounds (2.25 kg), and do not stack routers on

Caution

a desktop. Excessive distributed weight of more than 5 pounds, or pound point load of 5 pounds on top could

damage the chassis.

After you install the router, you must connect the chassis to a reliable earth ground. For the chassis ground connection

procedures, see the "Grounding the Chassis" section on page 18.

Wall-Mounting the Chassis

Caution

You can wall-mount the Cisco IAD2430, Cisco IAD2431, or Cisco IAD2432 IAD with either the right side or the

left side facing up; however, the front and back panels must be vertical. The Cisco IAD2435 IAD must be mounted

with the front panel facing up.

FX S

IA D 24 35 -8

FX S

WA N

Fa stE the rne

CO NS OL E

T1 /E1

0/1

0/0

AU X

12 V DC