Digitrax DH123PS 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Digitrax DH123PS에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitrax DH123PS 4 페이지. Mobile decoder

Installation Information

See the Digitrax Decoder Manual for complete decoder test procedures, installa-

tion instructions, programming and technical information. Digitrax manuals and

instructions are updated periodically. Please visit www.digitrax.com for the lat-

est versions, technical updates and additional locomotive-specific installations.

Installation Instructions

1. Carefully remove the locomotive's shell from the frame. Notice the orienta-

tion of the shell to the frame so that you can reinstall correctly.

2. The DH123D uses the DHWHP Digitrax Easy Connect 9 Pin Harness

System which consists of a 1.0" harness that has a Digitrax 9-pin plug on

one end and a DCC medium plug on the other. Remove the jumper plugs

from the DCC medium socket on the factory light board and plug in the

DCC plug end of the harness.

3. Plug the 9 Pin plug on the DHWHP harness into the socket on the decoder.

The plug is notched to fit easily into the socket in only one orientation.

4. Replace the loco shell. You are now ready to run your locomotive. The

DH123D is factory programmed to address 03. You can easily customize

the address and other features. See section "Customizing Your Decoder"

that follows.

Figure 1. DH123PS Wiring Diagram

Installation Notes:

1. Do not exceed the decoder's 500mA total function output rating.

2. To use a function output with an inductive (coil) type load, see the Digitrax Decoder Manual

for more information to avoid damage to the decoder.

3. See the Digitrax Decoder Manual for full details of wiring 12-16V lamps, 1.5V lamps, and

LEDs. Lamps that draw more than 80 mA when running require a 22 ohm 1/4 watt resistor in

series with the directional light function lead to protect the decoder.

Complete Train Control

Run Your Trains, Not Your Track!

NOTE: The Violet and Green leads of the harness are

www.digitrax.com

Warning: to prevent decoder

damage, be sure the motor

brushes are properly isolat-

ed before applying power.

not used by this decoder.