Digitrax DN163I0 매뉴얼 - 페이지 2

{카테고리_이름} Digitrax DN163I0에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitrax DN163I0 8 페이지. Mobile decoder dcc plug 'n play 1.5 amp/2.0 amp peak 6 fx3 functions, 0.5 amp

페이지 인쇄

P P a a r r t t s s L L i i s s t t

1 DN163I0 Decoder

I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n

See the Digitrax Decoder Manual for complete decoder test procedures, instal-

lation instructions, programming and technical information. Digitrax manuals

and instructions are updated periodically. Please visit www.digitrax.com for the

latest versions, technical updates and additional locomotive-specific installation

instructions.

I I n n s s t t a a l l l l a a t t i i o o n n I I n n s s t t r r u u c c t t i i o o n n s s - - I I n n t t e e r r M M o o u u n n t t a a i i n n S S D D 4 4 0 0 T T L L o o c c o o m m o o t t i i v v e e

1. Carefully remove the

locomotive's shell from

the frame. Notice the

orientation of the light

board inside so that you

can install the decoder

in the same orientation.

2. Carefully remove the

plastic light shroud at

the front of the loco and

loosen the frame screws

enough to allow the

removal of the light

board. Lift the board out

of the frame.

3. Apply the Kapton insu-

lating tape on the front

of frame to completely

cover the flat area above

the frame screw. Install

the decoder, square

CPU on the bottom,

between the frame

halves. The narrow part

of the decoder fits

between the frame with

the frame clips holding

it at the corners of the

decoder cutout. The

brass motor contacts

should contact the pads

on the bottom of the

decoder. The motor

contacts can also be

D D

C C

i i g g i i t t r r a a x x

o o m m m m a a n n d d

R R u u n n Y Y o o u u r r T T r r a a i i n n s s , , N N o o t t Y Y o o u u r r T T r r a a c c k k ! !

Light

shroud

Factory Light board

Figure 1: Remove loco shell

Motor

contacts

Figure 2: Loosen frame screws and

remove light board

replace light shrouds

Figure 3:

Place decoder in frame.

www.digitrax.com

C C

o o n n t t r r o o l l

1 Instruction sheet

frame screws

frame clips

Light

shroud

apply insulating

tape here

apply Kapton

insulating tape

here