Digitrax DN163I0 Podręcznik - Strona 2
Przeglądaj online lub pobierz pdf Podręcznik dla Konwerter mediów Digitrax DN163I0. Digitrax DN163I0 8 stron. Mobile decoder dcc plug 'n play 1.5 amp/2.0 amp peak 6 fx3 functions, 0.5 amp
Drukuj stronęP P a a r r t t s s L L i i s s t t
1 DN163I0 Decoder
I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n
See the Digitrax Decoder Manual for complete decoder test procedures, instal-
lation instructions, programming and technical information. Digitrax manuals
and instructions are updated periodically. Please visit www.digitrax.com for the
latest versions, technical updates and additional locomotive-specific installation
instructions.
I I n n s s t t a a l l l l a a t t i i o o n n I I n n s s t t r r u u c c t t i i o o n n s s - - I I n n t t e e r r M M o o u u n n t t a a i i n n S S D D 4 4 0 0 T T L L o o c c o o m m o o t t i i v v e e
1. Carefully remove the
locomotive's shell from
the frame. Notice the
orientation of the light
board inside so that you
can install the decoder
in the same orientation.
2. Carefully remove the
plastic light shroud at
the front of the loco and
loosen the frame screws
enough to allow the
removal of the light
board. Lift the board out
of the frame.
3. Apply the Kapton insu-
lating tape on the front
of frame to completely
cover the flat area above
the frame screw. Install
the decoder, square
CPU on the bottom,
between the frame
halves. The narrow part
of the decoder fits
between the frame with
the frame clips holding
it at the corners of the
decoder cutout. The
brass motor contacts
should contact the pads
on the bottom of the
decoder. The motor
contacts can also be
©2009 Digitrax, Inc
D D
C C
i i g g i i t t r r a a x x
o o m m m m a a n n d d
R R u u n n Y Y o o u u r r T T r r a a i i n n s s , , N N o o t t Y Y o o u u r r T T r r a a c c k k ! !
Light
shroud
Factory Light board
Figure 1: Remove loco shell
Motor
contacts
Figure 2: Loosen frame screws and
remove light board
replace light shrouds
Figure 3:
Place decoder in frame.
www.digitrax.com
C C
o o n n t t r r o o l l
1 Instruction sheet
frame screws
frame clips
Light
shroud
apply insulating
tape here
apply Kapton
insulating tape
here
2