argon audio FENRIS A4 매뉴얼 - 페이지 6

{카테고리_이름} argon audio FENRIS A4에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. argon audio FENRIS A4 7 페이지.

3. Quick start

1. Connect the speakers using the included speaker cable.

2. Connect the power cord into an electric outlet and into the back of the left speaker (which

has the amplifier). The LED light on the loudspeaker will turn on.

3. To pair your Bluetooth device, turn on the speakers and press and hold 'BT' on your

remote for about 3 seconds, until the LED starts blinking. Your speakers are now in pairing

mode. Activate Bluetooth on your playback device and scan for devices. Your speaker will

show up as "Argon Audio FENRIS". Press "pair" and you're connected. The LED light on the

speaker will change to solid blue. You're now ready to start listening to music!

4. Besides Bluetooth, your FENRIS speakers have four more inputs: TV ARC, D1, AUX and

Phono. FENRIS will automatically switch between the inputs, but you can also use the

included remote control to select your wished input.

5. When using the TV ARC input, you might need to set the digital sound output on your TV to

PCM. Consult your TV manual to see how.

6. When connecting a turntable to the Phono input on the FENRIS speaker, remember to also

connect the ground wire from the turntable to the metal GND screw (if applicable).

7. If you have an active subwoofer, connect it to the FENRIS speaker's Pre-out, using an RCA

cable and then connect the cable to your subwoofer.

8. We recommend a running-in time of your FENRIS speakers of approximately 15-20 hours

at normal listening level before you decide on the final positioning of the speakers.

APU (Auto Power Up)

When the FENRIS speakers receive input from any connected source (except Phono), they will

automatically power on (if powered off) and switch to the right input. This is called Auto Power

Up. Note: this will not happen if the speakers are already powered on and playing from another

source.

You can disable Auto Power Up (APU) if needed: simply press and hold the power button on

remote control for 5 seconds while the speakers are on. The speakers will now power off with

APU disabled. This will also disable automatic power off, meaning you need to turn off your

speakers manually.

To enable APU again, simply press and hold the power button for 5 seconds again when the

speaker is powered off.

Bluetooth unpairing

You can always press and hold the 'BT' button to remove all Bluetooth connections. Please note

that Bluetooth pairing is only available when the Bluetooth-input is selected.

w w w . a r g o n a u d i o . c o m

FENRIS A4, A5, A55