Digitrax SE74 매뉴얼 - 페이지 5

{카테고리_이름} Digitrax SE74에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitrax SE74 12 페이지.

4.0 SE74 Options: OPSW changes

havior can be configured using non-volatile OPSW's. The Factory default OPSW

settings will configure most common requirements.

Press and hold the OPS button for about 3 seconds until the green ID and

RTS LEDs blink alternately. Release the OPS button. The SE74 is now setup

to configure OPSW 1 to 48 by sending the required SW# as C or T to setup

an option.

Send a SW# in range 1-48 as C/T matching the valid settings from Table 1

OPSW settings shown below.

When finished press and hold OPS button for 3 seconds to exit OPSW setup

mode. The SE74 will now restart with the new OPSW settings.

Factory default OPSW settings are shown in BOLD.

OPSW's not in this table are reserved and should be kept at Factory default T

settings for predictable operation.

OPSW40 =C will reset to Factory defaults on OPSW mode exit

Table 1: SE74 OPSW setting table

OPSW# Default=bold Action:

T, T

37,36

C, T

T, C

C, C

C = Slow motion turnouts, T = pulse/solenoids

C =DCC Aspect control mode, T = SW control

C =Disable internal Routes

C = Bushby bit active

C = 8 input lines trigger Routes

C = DCC SW commands only

C = Do not echo Route SW's to Loconet

C = Solenoid pulse hi CD voltage

C = Send B2 not B0 input SW messages

C = 2-wire searchlight signals (figures 8/9)

C = Searchlight, T = 3 color signals

C = Common cathode signals, T=common anode

Flashing Yellow, 4th SW aspect

Flashing Red, 4th SW aspect

Dark, 4th SW aspect

Flashing Green, 4th SW aspect

C = Disable SW1021/1022 signal broadcast

C = Set Factory defaults

C = Make Lunar aspects Persistent

— 5 —

The SE74 configuration and be-