argon audio tt-2 소유자 매뉴얼 - 페이지 7
{카테고리_이름} argon audio tt-2에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. argon audio tt-2 12 페이지.
argon audio tt-2에 대해서도 마찬가지입니다: 소유자 매뉴얼 (12 페이지), 사용자 설명서 (12 페이지)
페이지 인쇄
Anti-skating force adjustment
The anti-skating force must be adjusted according to the mass of the cartridge as follows:
Downforce
Groove in the stub (8)
10 - 15mN
1
15 - 20mN
2
20mN and bigger
3
Slip the loop of the anti-skating weight's thread over the second groove of the stub to set the correct anti-skating force for the
factory-fitted cartridge. Feed the thread through the loop of the wire support (10).
Connection to the amplifier
The Argon Audio TT2 has a captive tonearm signal lead (12) for connection to the amplifier. Use the Phono input (sometimes labelled
gram, disc or RIAA) on your amplifier. Make sure that the phono input offers correct matching and amplification for the type of cartridge
used. Line inputs (such as CD, Tuner, Tape or Video) are not suitable.
Take care to connect the left and right channels correctly. The right channel is usually marked red, the left channel black or white.
Check the manual supplied with your amplifier for relevant information. The earthing wire of the tonearm lead should be connected
to the earth terminal on your amplifier (if provided).
If your amplifier does not have an input suitable for phono cartridges you will require a separate phono amplifier stage for MM or
MC cartridges such as the PRO-JECT PHONO BOX, the NAD RIAA AMP or the CAMBRIDGE RIAA AMP, which is then connected
between the record player and a free line level input of the amplifier.
NOTICE. Argon Audio TT2 USB version has build in RIAA AMP
The recommended load resistance for the factory fitted cartridge is: 47kohms /MM-input
st
from bearing rings
nd
"
"
"
rd
"
"
"
w w w . a r g o n a u d i o . c o m
TT- 2
7