argon audio TT-4 매뉴얼 - 페이지 5

{카테고리_이름} argon audio TT-4에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. argon audio TT-4 9 페이지.

Anti-skating adjustment

Turn the Anti-skating Control to the same value as the adjusted

downforce. The recommended downforce for the factory fitted

cartridge is 1.8 g

An external switching power adaptor (DC12V 0.5A) is supplied with

this turntable. Connect the turntable to a mains voltage of

110V/60Hz or 230V/50Hz.

There is an RCA output on the rear panel of the turntable. Connect

the RCA plug to this output, and then to the PHONO INPUT of your

amplifier. Red plug into R channel input, White plug into L channel

input. If your amplifier does not have an input suitable for phono

cartridges, you can turn ON the internal phono amplifier on the back

of the TT-4. The ground wire of the tonearm lead should be

connected to the ground terminal on your amplifier (if provided).

Playing a record

Place the record on the turntable. If it is a 45 rpm, you need to

place the adaptor on the record spindle.

Switch on the power.

Pull up the arm lifter, and then release the arm lock clip.

Place the cartridge vertically over the first track of the record.

Rotate the RPM knob to the speed you want to play, which will

cause the platter to start turning.

Lower the arm lifter. The stylus will touch the record and start

playing music.

When the record is done, lift the tone arm up, lead it back to the

arm rest and lock it.

To pause the playing, lift the tone arm by pull up the arm lifter,

and then turn the speed knob to "OFF".

Argon Audio A/S | DALI Allé 1, DK-9610 Nørager, Denmark

T T - 4 M a n u a l