Digitrax DSXSV9 지침 - 페이지 2

{카테고리_이름} Digitrax DSXSV9에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitrax DSXSV9 2 페이지. 9g turnout or motion control servo, with mount bracket and installation hardware

페이지 인쇄

2.0 DSXSV9 suggested Layout Installation

The servo arm moves the drive-wire through the turnout throw-bar hole

using an approx 1/2" access clearance hole or slot through the layout base

material, centered under the throw-bar drive hole. Use base-template below.

Pass the free end of the drive-wire through the access hole and then through

the throw-bar center hole. There will be excess drive-wire tip to trim later.

Align the servo mount so that the drive-wire will move in the throw-bar ac-

tuation direction. Set mount orientation so Thrown/ Clockwise horn rotation

will drive the throw-bar to the diverging or Thrown turnout direction .

Use two 5/16" long mount screws to hold the unit when in the correct posi-

tion. There are mount slots for up to 4 mounting screws and the slots allow

some fine position and orientation adjustments using screw pairs.

Connect the servo to a DS78V and drive to Thrown and Closed positions and

observe the turnout throw-bar moves as needed.

In the Thrown or Closed position, using eye protection, carefully trim the

drive-wire tip just below the rail tops, so as not to catch on any rolling stock.

With the drive-wire using the outermost horn arm hole, there will be about

+/- 0.25" of travel at a throw-bar offset of about 1" from the servo mount.

This will be fine for most HO and N scale turnouts and layout base material

depths. Any excess drive angle using the 0.6mm wire will provide com-

pliance and some spring tension on the rails. The heavier 0.8mm wire will

provide even more spring pressure, and not be required in most cases.

Always ensure at extreme T/C angles that the horn arm does not bind to

make servo jam ON. This may damage servo and is not covered under war-

ranty.

These steps are some of many possible methods to install the DSXSV9, and user

skills will allow many variations of these broad steps.

3.0 Warranty & Repair

Digitrax gives a 90 day Warranty against material and manufacturing defects on

the DSXSV9. Visit www.digitrax.com for instructions for returning items for re-

pair. Please return warranty items directly to Digitrax - DO NOT return

items to place of purchase.

Digitrax, Inc. reserves the right to make changes in design and specifications, and/or to

make additions or improvements in its products without imposing any obligations upon

itself to install these changes, additions or improvements on products previously manufac-

tured. The newest features are documented on the product pages of the website.

Digitrax, Inc. is not responsible for unintentional errors or omissions in this document.

Need Support? helpdesk.digitrax.com

2443 Transmitter Road

Panama City, FL 32404

www.digitrax.com

center pivot hole,

1 of 4 mount slots for

for no drive offset

5/16" long screws

DSXSV9 Mount base-template

— 2 —