Digitrax UT1 매뉴얼 - 페이지 5

{카테고리_이름} Digitrax UT1에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digitrax UT1 11 페이지. Traditional style loconet throttle

UT1 Throttle Diagram

Direction Toggle Switch

Section 3.3
Green LED Indicators
Section 3.12
F1/F4
Section 3.10
F0
F3
F0/F3
0
Section 3.9
SHIFT
Shift
Section 3.6
Address Selector
Section 3.4

3.0 UT1 Throttle Control Panel

3.1 General color codes

The UT1 is color coded according to how the keys are used.
The only RED key is Run/Stop. This is so you can't miss it in case of
emergency.
The BLUE keys are used in conjunction with the "SHIFT" key.

3.2 The Throttle Knob

Turn clockwise to increase the speed of your locomotive. Turn counter
clockwise to decrease the speed of your locomotive. There is about
300 degrees of rotation from 0 speed to full throttle.
Throttle Knob
Section 3.2
F2/F5
Section 3.11
F1
F4
F2
F5
ACQ
OFF
ON
DISP
ACQ/DISP
0
ST
Section 3.8
RUN
STOP
LOCO ADDRESS
Run/Stop
R
UT1
Section 3.7
Status LED
Section 3.5
Address Selector
Section 3.4
6
3.3 Direction Toggle Switch
Flip to the right for forward direction and to the left for reverse direction.

3.4 Address Selector Rotary Dials

Rotate these two selectors to select the two digit address ( 00 to 98 ) of
the locomotive you wish to control. The left selector dials in the 10s
and the Right selector dials in the 1s. Select address "99" to select a
locomotive or consist that has been "DISPATCHED" from another
Digitrax throttle. (See section on dispatched locomotives.)

3.5 Status Indicator

Indicates the status of the UT1.
·
Off indicates no locomotive is currently selected.
·
Green indicates a locomotive has been successfully selected.
·
Red indicates the direction and/or speed are out of correspondence
on a locomotive being selected.
·
Blinking orange indicates the UT1 is in "Switch Mode".

3.6 Shift Key

·
Press and hold to access F3, F4, F5.
·
Press in conjunction with the ACQ button to "Dispatch"

3.7 Run/Stop Key

·
Use as emergency stop. When held down will change locomotive
speed to "0". Turn throttle to "0" speed setting to regain control or
press RUN/STOP again.
·
RUN/STOP key is used in conjunction with other keys to activate
other throttle functions.

3.8 ACQ/DISP Key

·
Press to acquire any locomotive address after the address has been
dialed in with the rotary selectors.
·
When address selector reads "99", press "ACQ/DISP" to acquire
locomotive address that has been dispatched by another throttle in
the system.
·
If address selector is set to other than "99" press ACQ/DISP and
SHIFT to dispatch the locomotive address to another throttle in the
system.
·
Press ACQ/DISP along with RUN/STOP to set Option Switches in
your booster.

3.9 F0/F3 Key

·
Press F0 to toggle front and rear headlights on and off.
·
Hold "Shift" and press F3 to toggle Function 3 on and off.
7