Digitrax UT1 Podręcznik - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik dla Jednostka sterująca Digitrax UT1. Digitrax UT1 11 stron. Traditional style loconet throttle

Drukuj stronę

UT1 Throttle Diagram

Direction Toggle Switch

Section 3.3

Green LED Indicators

Section 3.12

F1/F4

Section 3.10

F0/F3

Section 3.9

SHIFT

Shift

Section 3.6

Address Selector

Section 3.4

3.0 UT1 Throttle Control Panel

3.1 General color codes

The UT1 is color coded according to how the keys are used.

The only RED key is Run/Stop. This is so you can't miss it in case of

emergency.

The BLUE keys are used in conjunction with the "SHIFT" key.

3.2 The Throttle Knob

Turn clockwise to increase the speed of your locomotive. Turn counter

clockwise to decrease the speed of your locomotive. There is about

300 degrees of rotation from 0 speed to full throttle.

Throttle Knob

Section 3.2

F2/F5

Section 3.11

ACQ

OFF

DISP

ACQ/DISP

Section 3.8

RUN

STOP

LOCO ADDRESS

Run/Stop

UT1

Section 3.7

Status LED

Section 3.5

Address Selector

Section 3.4

3.3 Direction Toggle Switch

Flip to the right for forward direction and to the left for reverse direction.

3.4 Address Selector Rotary Dials

Rotate these two selectors to select the two digit address ( 00 to 98 ) of

the locomotive you wish to control. The left selector dials in the 10s

and the Right selector dials in the 1s. Select address "99" to select a

locomotive or consist that has been "DISPATCHED" from another

Digitrax throttle. (See section on dispatched locomotives.)

3.5 Status Indicator

Indicates the status of the UT1.

Off indicates no locomotive is currently selected.

Green indicates a locomotive has been successfully selected.

Red indicates the direction and/or speed are out of correspondence

on a locomotive being selected.

Blinking orange indicates the UT1 is in "Switch Mode".

3.6 Shift Key

Press and hold to access F3, F4, F5.

Press in conjunction with the ACQ button to "Dispatch"

3.7 Run/Stop Key

Use as emergency stop. When held down will change locomotive

speed to "0". Turn throttle to "0" speed setting to regain control or

press RUN/STOP again.

RUN/STOP key is used in conjunction with other keys to activate

other throttle functions.

3.8 ACQ/DISP Key

Press to acquire any locomotive address after the address has been

dialed in with the rotary selectors.

When address selector reads "99", press "ACQ/DISP" to acquire

locomotive address that has been dispatched by another throttle in

the system.

If address selector is set to other than "99" press ACQ/DISP and

SHIFT to dispatch the locomotive address to another throttle in the

system.

Press ACQ/DISP along with RUN/STOP to set Option Switches in

your booster.

3.9 F0/F3 Key

Press F0 to toggle front and rear headlights on and off.

Hold "Shift" and press F3 to toggle Function 3 on and off.