Cisco Performance Routing Engine 5 하드웨어 설치 매뉴얼 - 페이지 23
{카테고리_이름} Cisco Performance Routing Engine 5에 대한 하드웨어 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Performance Routing Engine 5 35 페이지.
Cisco Performance Routing Engine 5에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
Step 4
Perform Step 1 to Step 3 to upgrade the FPGA on the standby PRE5 module.
Step 5
Power cycle the chassis.
After the power cycle, the active RP reboots with the latest FPGA programmable firmware and comes online.
Installing the Cisco PRE5 Module Peripherals
This section describes the peripherals that come with the Cisco PRE5 module and how you can install them. You have two options
for the peripherals:
• Cable holder and PRE5 front-panel bezel—For efficient cable management and to protect cables from being disconnected or
damaged by accidental contact.
• Cable holder and air-filter bezel—For efficient cable management and to avoid dust into the Cisco uBR10012 router.
Installing the Air Filter Bezel on the Cisco uBR10012 Router
The air filter bezel is used to prevent the flow of dust into the Cisco uBR10012 router.
Caution
To prevent damage to the router, do not attempt to pry off the plastic bezel.
Before you begin
Read the
General Safety Guidelines, on page 7
Procedure
Step 1
Align the stud bolts with the stud holes and push them into the stud holes until the bezel is seated completely.
Step 2
Press the air-filter clips towards each other as shown in the figure below, and attach the air-filter clips into the edge of
the sheet-metal part of the Cisco uBR10012 router.
before installing any module.
23