Cisco Performance Routing Engine 5 Manual de instalação do hardware - Página 23
Procurar online ou descarregar pdf Manual de instalação do hardware para Hardware de rede Cisco Performance Routing Engine 5. Cisco Performance Routing Engine 5 35 páginas.
Também para Cisco Performance Routing Engine 5: Manual de início rápido (2 páginas)
Imprimir página
Step 4
Perform Step 1 to Step 3 to upgrade the FPGA on the standby PRE5 module.
Step 5
Power cycle the chassis.
After the power cycle, the active RP reboots with the latest FPGA programmable firmware and comes online.
Installing the Cisco PRE5 Module Peripherals
This section describes the peripherals that come with the Cisco PRE5 module and how you can install them. You have two options
for the peripherals:
• Cable holder and PRE5 front-panel bezel—For efficient cable management and to protect cables from being disconnected or
damaged by accidental contact.
• Cable holder and air-filter bezel—For efficient cable management and to avoid dust into the Cisco uBR10012 router.
Installing the Air Filter Bezel on the Cisco uBR10012 Router
The air filter bezel is used to prevent the flow of dust into the Cisco uBR10012 router.
Caution
To prevent damage to the router, do not attempt to pry off the plastic bezel.
Before you begin
Read the
General Safety Guidelines, on page 7
Procedure
Step 1
Align the stud bolts with the stud holes and push them into the stud holes until the bezel is seated completely.
Step 2
Press the air-filter clips towards each other as shown in the figure below, and attach the air-filter clips into the edge of
the sheet-metal part of the Cisco uBR10012 router.
before installing any module.
23