Cisco PIX 501 빠른 시작 매뉴얼 - 페이지 12

{카테고리_이름} Cisco PIX 501에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco PIX 501 18 페이지. Data sheet
Cisco PIX 501에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (20 페이지), 데이터시트 (8 페이지), 빠른 시작 매뉴얼 (21 페이지), 빠른 시작 매뉴얼 (20 페이지)

페이지 인쇄

Set a Static IP Address

The default configuration enables DHCP for the outside

interface so that the PIX 501 can automatically obtain an IP

address from your network service provider. If you are not using

DHCP, you need to set a static IP address on the outside

interface.

To set a static IP address for the outside interface using PDM:

Click the System Properties tab.

Step 1

Click Routing>Static Route in the Categories tree.

Step 2

Click Add and the Add Static Route dialog box appears.

Step 3

Click the Interface Name list to select the outside interface to configure. The interface name

Step 4

is enabled in System Properties>Interfaces.

In the IP Address box, enter the external network static IP address.

Step 5

In the Gateway IP box, enter the IP address of the gateway router that is the next hop address.

Step 6

In the Mask box, enter the network mask address that applies to the IP address you entered

Step 7

in Step 6.

Click OK.

Step 8

Step 9

Click Apply to PIX, and the changes are applied to the running configuration.