Cisco PIX 501 Panduan Memulai Cepat - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Jaringan Cisco PIX 501. Cisco PIX 501 18 halaman. Data sheet
Juga untuk Cisco PIX 501: Panduan Memulai Cepat (20 halaman), Lembar data (8 halaman), Panduan Memulai Cepat (21 halaman), Panduan Memulai Cepat (20 halaman)

Halaman Cetak
Cisco PIX 501 Panduan Memulai Cepat
Set a Static IP Address
The default configuration enables DHCP for the outside
interface so that the PIX 501 can automatically obtain an IP
address from your network service provider. If you are not using
DHCP, you need to set a static IP address on the outside
interface.
To set a static IP address for the outside interface using PDM:
Click the System Properties tab.
Step 1
Click Routing>Static Route in the Categories tree.
Step 2
Click Add and the Add Static Route dialog box appears.
Step 3
Click the Interface Name list to select the outside interface to configure. The interface name
Step 4
is enabled in System Properties>Interfaces.
In the IP Address box, enter the external network static IP address.
Step 5
In the Gateway IP box, enter the IP address of the gateway router that is the next hop address.
Step 6
In the Mask box, enter the network mask address that applies to the IP address you entered
Step 7
in Step 6.
Click OK.
Step 8
Step 9
Click Apply to PIX, and the changes are applied to the running configuration.
12